-- Biped material list --

- Drawing & material feet (3mm Plywood or 1,5mm alu, FR4 epoxy board)
- Drawing & material base plate (3mm Plywood or 1,5mm alu, FR4 epoxy board)
- Egel kit with shield
- 4x standard servo (HS-300/HS-311, Towerpro 996 or similar)
- Bluetooth module HC06 (HC-06 Bluetooth serial module)
- Alu strip 2x 80mmx10mmx2mm flat (see building plan)
- Switch 3 Amp. ( MTS-102 SPDT )
- 3x 15 mm column spacer m2
- 4x 10mm column spacer m3
- 4x 27mm column spacer m3
- 50mmx30mmx5mm of styrofoam
- Some wired, solder & connectors
- A few M3 bolts, nuts and small metal screws
- 6 cm double-sided sticky tape


One of these power supply's

1) Simple version with ordinary battery's:
    - 3x 1,5 Volt alkaline AA-battery
    - 1x 3 x AA battery holder ( Holder Box Case )

2) Deluxe version, with a reloadable accu:
    - LiPo accu 7,4V - 900mAh (Lion power 7.4V 900MAH 25C 2s lipo)
    - Switched power supply 3 Amp. 5 Volt LM2596 (LM2596S DC-DC)
    - Lipo under voltage protection (See schematic)
    - LiPo charger! (ImaxRC B3 Pro Compact, Balance Charger)